 |
1.
Tape up the covers. Using a pencil, draw a ring
around the eyelet of the top-center fastener. |
 |
....to make a "ring"
on the fiberglass. |
 |
2.
Hold twist-lock up to the "ring" just
drawn. |
 |
3.Mark
the rig where the two set-screws should go. |
 |
4.
Make two 1/4" deep pilot holes using a 7/64"
drill bit. |
 |
5. Fill the holes with silicone
sealant, to prevent water leakage. |
 |
6.
Attach the twist-lock to the body of the coach
using the Phillips head, stainless steel set screws
provided. |
 |
7.
Mount the bottom-center fastener, then mount the
four corner fasteners. |
 |
8.
Mount the side covers in the same manner. |
 |
9.
The job is complete! |
| |
|
| |
|
